JAROLIFT TDRCT04 Mode D'emploi Original page 23

Setting the jog mode
You can conveniently control blinds in the "Jog mode". When you press the UP button, the blind does not immediately move
to the upper end position. The drive is controlled by briefly pressing it and thus opens the blind only step by step to open the
slats. The function is also used for convenient control of roller shutters to open the ventilation slits. Only when you press and
hold the UP button for longer than approx. 3 seconds, the drive is controlled in "self-retaining" and the blind is fully opened.
The example shown is exemplary and depends on the respective receiver type. Please refer to the instructions of the
receiver!
Activating / deactivating the jog mode
1. Press the UP and DOWN buttons on the transmitter simultaneously.
2. Then press the STOP button 6 times.
3. Press the DOWN button within 10 seconds.
The motor will confirm the activation (deactivation) of the jog mode by vibrating briefly.
Taught-in transmitter:
Press the up/down
button press.
max. 10 sec.
To deactivate the jog mode, repeat the procedure.
Delete handheld transmitter
ATTENTION!
All taught-in (programmed) transmitters are deleted! Individual deletion of a transmitter is not possible!
The example shown is exemplary and depends on the respective receiver type. Please refer to the instructions of the
receiver!
1. Simultaneously press the UP and DOWN button on a taught-in transmitter.
2. Then press 6x the STOP Key.
3. Press Within 10 seconds, press the OPEN button.-button. The motor will confirm the deletion of the transmitters by
a short vibration.
Taught-in transmitter:
Press the up/
down button
simultaneous-
max. 10 sec.
ly.
Press the
stop button
6 times.
max. 10 sec.
Press the
stop button
6 times.
max. 10 sec.
PROGRAMMING
Press the DOWN
key once.
(engine vibrates)
Press the UP key
once.
(engine vibrates)
23