JAROLIFT TDRCT04 Mode D'emploi Original page 21

SETTING THE AUTOMATIC UP AND DOWN TRAVEL TIMES
You can programme 8 up and 8 down times. You can assign these up or down
times to a desired channel or to all four channels.
1. Press the K2 key in the main menu to enter the driving time menu. An alarm
clock is shown in the upper left corner of the display.
2. Press the K2 button to cycle through the individual memory locations (the
arrows on the left side of the display indicate whether it is an up or down time).
The display ( ) indicates that the memory location is inactive and that no mo-
vement time will be executed for this channel. If a time is already displayed here,
continue with point 4, if no time is displayed, continue with point 3.
3. To activate the deactivated memory location, press the K3 button. To deactivate the memory location again, please press
the K3 key repeatedly until the time display returns to (
4. Press the K1 button to set the driving time. The hour display flashes and can be set using the up/down button.
5. Press the K1 key again to switch to the minute setting. Here, too, you can set the minutes using the up or down button.
6. After pressing the K1 key again, you reach the weekday setting. Here you set the day(s) of the week for which the time you
have just set is valid. Again, use the Up/Down buttons to select your desired setting.
You can choose between:
• single weekday = e.g. "Tu" for Tuesday
• shortened working week = Mo Tu We Th Fr (Monday to Friday)
• entire working week = Mo Tu We Th Fr Sa (Monday to Saturday)
• entire week = Su Mo Tu We Th Fr Sa (Monday to Sunday)
7. If all settings are correct, confirm your entry with the K2 key. The settings are saved.
- to make further changes, start again from the beginning.
8. To assign a specific channel or all channels to the timetable you have just created, press the K3 button.
9. The channel for which this schedule is intended is marked by a frame in the lower channel bar.
- If you want to assign all channels to this time control, press the K3 key repeatedly until all four channels are marked.
Attention!
After the entire marking of the four channels has been exceeded by pressing the K3 key, the memory location changes
back to "inactive" mode.
Then press the K3 key once more, the space is reactivated and the first channel in the channel display is highlighted again.
10. When you are satisfied with your settings, press the K2 key to move to the next memory location and start again.
and start again.
11. Press the stop button to exit the programming mode.
Activating and deactivating the timer function
Make sure you are in the main menu. To enter the main menu from any other menu, briefly press the stop key.
In the main menu, hold down the stop key and briefly press the K2 key to activate or deactivate the timer function. If the timer
is active, the alarm clock symbol is displayed in the main view.
We
1 2 3 4
Timer
active
Memory location 1 for the ramp-up time
) displays.
We
1 2 3 4
PROGRAMMING
Timer
inactive
21