Amp Clip Led's - YORKVILLE DJM806 Manuel De L'utilisateur

POWER AMPLIFIER
POWER AMPLIFIER FEATURES
•
A total output of 800 watts with well-proven, reliable AUDIOPRO technology.
•
Industry leading specifications for distortion, damping, and efficiency.
•
Comprehensive protection against low or even shorted loads, overheating and
DC damage to speakers.
•
A combination of standard 1/4" and high-current Speakon™ output connectors.
POWER AMPLIFIER - GENERAL
The DJM806 has an 800 watt stereo power amplifier. Each channel has an input
sensitivity of +4dBv (1.4 volts RMS) for full power output and can deliver over 400
watts into a 4 Ohm speaker load. The amplifier incorporates computer designed
internal heatsinks and a variable-speed fan which automatically provides quiet
operation consistent with cooling requirements. Cool air is drawn into the front of
the mixer, and heated air is expelled along the bottom of the back. Even at
maximum power, this arrangement results in quiet, dependable performance.
PLEASE NOTE: MAINTAIN CLEAR AIR VENTS AT THE FRONT AND BOTTOM REAR
OF THE MIXER. THEY ARE ESSENTIAL FOR PROPER OPERATION. BLOCKING THE
FREE FLOW OF AIR THROUGH THE MIXER WILL RESULT IN SYSTEM SHUT-DOWN
DUE TO OVERHEATING. AFTER THE DJM806 COOLS DOWN, OPERATION WILL
BE RESTORED. THIS SHOULD NEVER HAPPEN IF ADEQUATE VENTILATION IS
PROVIDED. PLEASE KEEP THE VENTS FREE OF OBSTRUCTIONS.

AMP CLIP LED'S

Located on the right side of the control panel below the POWER LED, the AMP
CLIP indicators flash when one or both channels of the built-in power amp are
running out of headroom. Reduce the MAINS fader level if AMP CLIP activity
becomes constant. Clipping distortion can damage speakers.