Before First Use; Control Panel - camry Premium CR 7724 Mode D'emploi

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 13
2. Never use the device if it has fallen from a height before and shows visible signs of
damage.
3. Do not use extension cords or other electrical outlets that do not meet the applicable
standards and electrical regulations.
4. Any repairs, dismantling or replacement of any parts should always be made by a
specialized facility.
5. If the device and elements such as electrical contacts are wet, the plug or cable should be
dried before using the device and its components.
6. Do not use the device with wet hands.
7. When there is a risk that the device has been damaged NEVER try to repair the device
yourself.
8. Never wash the device under running water or in such a way that water drips into it.
9. Do not use accessories that are not recommended by the manufacturer. They may pose a
danger to the user and may cause damage to the device.
10. Ensure that the device has cooled down before storing.
11. Do not touch the housing during use. During operation, use only knobs and switches.
After switching off, wait for the device to cool down.
12. CAUTION: Some parts of this device may become very hot during operation and cause
burns.
III. BEFORE FIRST USE
1. Remove all packing material and straighten the power cord
2. During installation, in no case may the device be covered with insulating material or similar material
3. When assembling the device, beams and rafters should not be cut or cut
4. Before first use read all instructions for use.
5. Check if the voltage listed on the product ratting label corresponds to the voltage of the power network in your home
6. Do not use the device unless the feet are correctly attached
7. Keep the mains lead away from the hot body of the device.
8. The device is not intended for use in bathrooms, laundry areas or similar indoor locations. Never place the device where it may fall into a
bathtub or other water container.
9. Do not use outdoors.
10. Do not place any objects close to the outlet grills or the air intake openings of the device when operating.
11. Do not place the device on carpets having a very high hairs.
12. Always ensure that the device is placed on a firm level surface. Ensure that the device is not positioned close to curtains or furniture as
this could create a fire hazard.
13. Do not position the device in front of, or immediately below, a wall socket.
14. Do not position the under the window.
15. Do not insert any object through the heater outlet or air intake grills of the device.
16. Do not use the device in areas where flammable liquids are stored or where flammable fumes may be present.
17. Always unplug the device when moving it from one location to another .
INSTALLATION IN STANDING POSITION ON THE FLOOR
Before using the device, the feet (supplied separately in the carton), must be fitted to the device. These are to the base of the heater using
the 4 self-tapping screws provided. Take your care to ensure that they are located correctly in the bottom ends of the device side moldings.
PRODUCT DESCRIPTION: CONVECTION HEATER WITH REMOTE CONTROL
1. Power switch
4. Feet
7. Remote control

CONTROL PANEL

A. Power button
C. TURBO FAN button
2. Air outlet grid
5. Housing
8. Fan's ventilation grid
B. Heat output button
D. Timer button 1-24 hours
7
3. Air inlet grid
6. Control Panel LCD
9. Compartment for remote control

Publicité

Table des Matières
loading

Table des Matières