Your Device At A Glance; Using For The First Time; Operation; Cleaning - Lux Tools K-FSP-3 Manuel D'utilisation

Airbrushpistole_101107.book Seite 20 Mittwoch, 6. April 2016 2:40 14
GB

Your device at a glance

► P. 2, item 1
1. Handle
2. Compressed air valve
3. Compressed air canister
4. Paint nozzle
5. Connection for paint mixing glass
6. Connection for compressed air
Scope of delivery
► P. 2, item 2
7. Compressed air hose M5×0.45
8. Reducing nipple 13.7 mm (¼" NPT) /
M5×0.45
9. Spray stylus
10. Paint mixing glass with connection lid
11. Combination wrench
12. Regulation valve for compressed air can-
ister
13. Compressed air hose 13.7 mm (¼"
NPT) / M5×0.45
14. Adapter 13,7 mm (¼" NPT) / Compres-
sor plug-in coupling
15. Paint mixing glass with lid closure
16. Mixing pipette
• Operating instructions

Using for the first time

Compressed air supply
NOTICE! Risk of damage to the
unit! Only operate the device with
cleaned and condensation-free com-
pressed air.
• Fittings and hoses must be designed to
handle the pressure and the necessary
quantity of air.
• Always use a compressed air mainte-
nance unit with filter pressure reducer.
Connecting to a compressed air canister
– Unscrew the valve pin on the top of the
regulation valve (12).
– Screw the regulation valve to the com-
pressed air canister.
– Connect to the compressed air hose (7)
or (13) the regulation valve.
– Connect the compressed air hose to the
compressed air connection (6) of the
spray stylus.
Connecting a compressor
– Connect the adapter for the compressor
quick coupling (14) to the compressed air
hose (7) or (13).
20
– Connect the compressed air hose to the
compressed air connection (6) of the
spray stylus.
– Fit the compressed air hose to the plug-
in coupling and engage securely.

Operation

– Switch on the compressed or screw the
valve pin on the top of the regulation
valve (12) into place.
– Set the working pressure on the com-
pressor (operating pressure: ► Technical
data – p. 22) or regulate using the valve
pin on the top of the regulation valve (12).
Fill with paint
NOTICE! Risk of damage to the
unit! Observe the paint manufac-
turer's notes!
– Fill paint in the paint mixing glass.
– Thin the paint with water or suitable sol-
vent to the required viscosity.
– Fit the paint mixing glass to the connec-
toin (5).
Spraying
– Press the compressed air valve (2) to
start the spraying process.
– Rotate the paint nozzle (4) to set the
spray pattern.
– Guide the spray stylus calmly and evenly
over the object.

Cleaning

Cleaning overview
After each use
What? How?
► Cleaning the de-
Clean the device.
vice – p. 20
Cleaning the device
NOTICE! Risk of damage to the
unit! Clean unit carefully after every
use.
Dried on paint residue will render the
unit useless.
– Empty the paint mixing glass after spray-
ing and spray the remaining paint until
only compressed air exits.