Dubbing; Information On Dubbing - Magnavox H2160MW9 Mode D'emploi

Information on Dubbing

You can dub the contents of the HDD to DVD or vice verse. Before you start dubbing, refer to page 41 to see the
recording compatibility.
Guide to Dubbing Menu Display
1
HDD DVD
Add
2
Delete All
Dubbing Start
1 Dubbing direction
2 Dubbing menu
3 Remaining recordable space
4 Dubbing list
5 Current page number / total number of pages

DUBBING

3
3000 MB
Dubbing List
4
5
1/1
Recording Mode for Dubbing
"High"
This unit is compatible with the high speed dubbing from
HDD to DVD.
If you dub a title recorded in SLP mode to DVD+R/-R,
dubbing speed will be 24 times at the maximum. To
perform the high speed dubbing, set the recording mode
to "High".
• Duration of high speed dubbing will vary depending on
the recording mode or the title amount.
• High speed dubbing is not available when;
- recording mode is set to other than "High".
- dubbing from a DVD to the HDD.
- there is not enough space in the HDD.
- duration of the title is more than 5 hours.
• During dubbing (except for high speed dubbing), you can
use [STOP C] on the front panel or press [STOP C] for 2
seconds on the remote control, and any other buttons will
be invalid.
"Auto"
When "Auto" is selected as a recording mode, the unit
calculates how much time is available on the disc and
selects the best recording mode available automatically.
• The recording may be cut short when the available
recording space of the disc is too limited.
Note on dubbing
• During normal dubbing, you can watch the playback
picture of the title being dubbed (the audio cannot
be changed). During high speed dubbing, however,
the playback picture will not appear.
• Dubbing of a "copy-once only" program is not
possible with this unit.
• If you stop the dubbing halfway, the contents will be
dubbed up to the point where you stop the dubbing
(except for the high speed dubbing). With high
speed dubbing, nothing will be dubbed if you stop it
halfway.
• To stop the dubbing in progress, press [STOP C] on
the front panel or press [STOP C] for 2 seconds on
the remote control.
Other modes
Refer to page 40 for the information on other modes.
EN EN 51 51