Channel Setting; Auto Channel Scan - Magnavox H2160MW9 Mode D'emploi

If you have changed antenna connection, we recommend that you program available channels in your area with the
following procedures.

Auto Channel Scan

STANDBY-ON DTV/TV
.@/: .@/:
GHI GHI
PQRS
PQRS
SETUP SETUP
DISC MENU
DISPLAY
V.REPLAY
RAPID PLAY
D.DUBBING
TIMER
Note
• If the auto channel preset is canceled during
presetting, some channels not yet preset may not be
received.
28 28 EN EN

CHANNEL SETTING

OPEN/
SOURCE CLOSE
ABC ABC DEF DEF
CHANNEL CHANNEL
JKL JKL MNO MNO
TUV WXYZ
TUV WXYZ
SPACE SPACE CLEAR
AUDIO REPEAT HDMI
TITLE
OK OK
RETURN RETURN
V.SKIP
HDD DVD
REC MODE REC
1
Press [SETUP] and use [K / L] to
select "General Setting", then press
[OK].
"General Setting" menu will appear.
2
Use [K / L] to select "Channel", then
press [OK].
"Channel" menu will appear.
3
Use [K / L] to select "Auto Channel
Preset", then press [OK].
4
Use [K / L] to select the type of
broadcasting signal, then press [OK].
Auto Channel Preset
Antenna
Cable (Analog)
Cable (Analog / Digital)
The unit will start getting channels available in
your area.
• When aerial antenna is connected, select
"Antenna".
• When connected to CATV, select "Cable
(Analog)" or "Cable (Analog/Digital)".
To cancel the auto channel preset during
scanning:
Press [RETURN] or [SETUP] to cancel.
5
When scanning is over, press [SETUP]
to exit.
To cycle through only the memorized channels, use
[CHANNEL / ].
To select a channel directly (including the ones not
memorized), use [the Number buttons] and [ • ] (for
digital TV channels).