Rf Modulator Connection - Magnavox H2160MW9 Mode D'emploi

Masquer les pouces Voir aussi pour H2160MW9:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

RF MODULATOR CONNECTION

If your TV has antenna in jack only, it is still possible to connect this unit to your TV by using a commercially available
stereo audio/video RF modulator. In this case, follow the instructions below.
1) Disconnect the power cords of the devices from the AC outlet.
2) Make the connection as illustrated below.
3) Set your RF modulator's channel 3/4 switch to either 3 or 4, whichever the TV channel is least used in your area.
If your RF modulator has a modulator/antenna switch, set it according to the manual supplied with the RF
modulator.
4) Plug in the power cords of the devices to the AC outlet.
5) Turn on your TV and choose the same channel as you set the RF modulator's channel 3/4 switch to.
For more details, follow the manual supplied with the RF modulator.
VHF / UHF
antenna
or
cable TV
company
Supplied cables used in this connection are as follows:
• RF coaxial cable x 1
• RCA audio cable (L/R) x 1
• RCA video cable x 1
Please purchase the rest of the necessary cables at your local store.
Note
• RF modulator is not supplied with this unit. You need to purchase it at your local store.
• The quality of picture may become poor if this unit is connected to an RF modulator.
16
16
EN
EN
rear of this unit
RF coaxial
IN
cable
OUT
ANTENNA
rear of your RF modulator
RF coaxial cable
VIDEO
VIDEO
Y
IN
OUT
IN
L
OUT
R
IN
OUT
COAXIAL
AUDIO IN
ANTENNA
S-VIDEO AUDIO OUT
S-VIDEO
(
)
L1
VIDEO
OUT
L
R
AUDIO OUT
RCA audio cable
(not supplied)
3
4
R
L
ANT. IN
CHANNEL
AUDIO IN
VIDEO IN
Set channel 3 or 4
RCA video
cable
rear of your TV
ANT. IN
RF coaxial cable
TO TV

Publicité

Chapitres

Table des Matières
loading

Table des Matières