Care And Maintenance - Kobalt NEXT GENERATION OF TOUGH TOOLS SGY-AIR160TZ Mode D'emploi

OPERATING INSTRUCTIONS
7. Overlap strokes just enough to obtain an even
and fine coat. (See Figure 8)
NOTE Two thin coats of paint will yield better
spraying results and have less chance of runs than
one heavy layer.
8. Use a piece of cardboard as a shield to catch
overspray at the edges of workpiece and protect
other surfaces. Use masking tape (not included)
to cover other areas if needed.

CARE AND MAINTENANCE

To properly maintain and keep your sprayer working at its optimal performance,
it is recommended that the spray gun nozzle be cleaned and cleared of any clogs or
debris buildup using paint thinner or lacquer thinner. DO NOT USE ANY ACID
BASED SOLVENTS, AS ACID BASED SOLVENTS CAN DAMAGE THE SPRAYER.
Please consult with your local retailer in choosing the right solvent materials.
BEFORE PERFORMING ANY CLEANING OR MAINTENANCE REMOVE SPRAY
GUN FROM AIR SUPPLY AND KEEP AWAY FROM ANY IGNITION SOURCES.
COMPLETELY EMPTY CUP WHEN PERFORMING AND MAINTENCE OR
CLEANING.
1. Pour enough solvent material(s) into container so that nozzle will be completely
submerged in solvent material.
NOTE: There are two methods for properly submerging spray gun nozzle into
cleaning solvent material(s).
Method 1: Remove the spray gun nozzle completely from
spray gun and place into a container that will not cause
solvent deterioration when solvent material(s) are added
(See Fig. 9).
Method 2: Keeping the spray gun nozzle attached to the
spray gun housing. Empty canister and submerge the front
end of the spray gun only (See Fig. 10). Make sure that only
the spray gun nozzle is submerged in solvent material(s). (If
using method 2, make sure a suitable container is used which
can not easily tip over. If the container used does tip over,
you will spill solvent material(s), causing a potential safety
hazard.)
NOTE: Make sure that you never submerge any part of the
spray gun housing into solvent material(s), as air passages
would become clogged with dirty solvent. This would cause
the gaskets inside the gun housing to dry out, causing faster
wear and tear on the item.
9
Solvent material
Nozzle
10
Solvent
material
Nozzle