Kobalt NEXT GENERATION OF TOUGH TOOLS SGY-AIR160TZ Mode D'emploi page 10

OPERATING INSTRUCTIONS
5. Keep the gun at a 90° angle to the surface
(see Figure 5) while spraying.
NOTE Always keep the gun in motion while
spraying. Stopping gun movement in mid-stroke
will cause a build-up of paint and will result in runs.
Do not fan the gun from side to side while painting.
This will cause a build-up of paint in the center of
the stroke and an insufficient coating at each end
(See Figure 6).
6. Trigger the gun properly. Start the gun moving at
the beginning of the stroke before squeezing the
trigger (J1/J2) and release the trigger (J1/J2)
before stopping gun movement at the end of
s r t k o . e This procedure will feather/blend each
with the next without showing overlap or
t s o r e k
unevenness. (See Figure 7)
NOTE
The amount of paint being applied can be
varied by the speed of stroke, distance from
workpiece and adjustment of fluid adjustment knob
(G1/G2). If speed of stroke is too slow, paint will
be wet on workpiece and may run. If speed of
stroke is too fast, paint will be dry and uneven on
workpiece.
5
6 - 9 in.
6
Thin coat Heavy coat
6 - 9 in.
Thin coat