Electrical Connections - Dri-Eaz Rover HVE F354 Manuel De L'utilisateur

Masquer les pouces Voir aussi pour Rover HVE F354:

Manuel de l'utilisateur (12 pages)

Table des Matières

Les langues disponibles

2. Follow a clear pattern, so you cover all floor surfaces but do

not repeat any area unnecessarily.

3. While extracting, create an overlapping pattern for best re-

sults. Overlap each pass by about half the width of the pre-

vious pass.

4. To turn the Rover HVE in another direction, gently move the

joystick in the direction needed. Do not do "wheelies" or jerk

the unit sideways; this may cause delamination damage to

carpet.

5. The Rover HVE will drive straight ahead, straight backward

and turn in a full circle. Ideally, extract with the grain of the

carpet. If the Rover HVE begins to track (i.e. stops moving in

the direction the joystick is moved) it needs to be re-

calibrated. To do this, push the joystick forward and press the

calibration button on the product label side of the control box

at the same time. (The calibration button is shown in the

drawing on page 1; look for mark indicating button location in

the center of the "H" on the product label).

6. Run the unit on Low speed if carpet and pad are extremely

wet, then on High speed as the carpet and pad become less

wet.

7. From time to time, check the clear take-up tube leading to the

hose connection (shown, below). When the tube indicates

that only a small amount of water is being removed, stop ex-

tracting to minimize any carpet delamination.

Check clear take-up tube regularly during extraction.

07-01549 F 2011-07 Warranty 07-00422

Clear take-up tube

Transporting and Storing

1. To prepare the Rover HVE for transporting, loading into a

van or for storage, first lay it on a flat surface (with small front

loading wheels facing up). While supporting the handle with

one hand, pull out the pins on each side with the other hand.

Next fold the handle all the way down to the horizontal posi-

tion, then replace the pins to lock the handle down. Pick up

unit by handlebars and place unit upright onto the small front-

loading wheels. Wrap the power cord around your arm then

place in the cord compartment located under the unit. Use

the small front loading wheels for ease of transporting while

using the molded-in handle to assist in loading or carrying the

unit.

2. When transporting in a van, secure the Rover HVE against

the wall (Shown, below) and strap it into place.

NOTICE! Store securely in an upright position to avoid any da-

maging impact to the motor, gears, and other internal parts.

Store securely in upright position.