Using The Tilt And Wall Hanging Options - Verilux HappyLight Liberty Serie Mode D'emploi

Bulb Removal and Replacement — continued Bulb Removal and Replacement — continued
4. Unscrew the two blue thumb screws that hold
the black bulb holder and the bulb itself (C).
5. Gently pull up the black bulb holder to expose
the base of the bulb (D).
6. Holding the bulb at its base, gently lift out the
old bulb, pulling it slowly and gently away from
the lamp body as you lift it upward (E).
7. Remove the black bulb holder by lifting it over
the top of the old bulb.
8. Place the black bulb holder over the top of the
new bulb.
9. Gently insert the new bulb into the receptacle
from which you removed the old bulb (F). A
"click" sound will indicate the bulb is properly installed.
10. Lower the black bulb holder onto the bulb base. Reinstall the two
blue thumb screws.
11. Replace the lens, first by inserting its base into the opening in the
lamp base and then by aligning its top with that of the lamp base
(G). Snap lens into place.
WARNING:
a pacemaker, implantable defibrillator, insulin pump, any other
type of electro-mechanical device, or brain shunts that contain
magnets, keep sufficient distance (about 6 inches) between the
implanted device and the lamp.

Using the Tilt and Wall Hanging Options

The HappyLight Liberty Series Energy Lamp offers
several ways to direct light where you want it, so you can
have more freedom of movement without compromising
the quality of the therapy:
1. Your HappyLight has a tilt range of 15° forward and
15° backward (H): Simply loosen the two blue thumb
screws on the back of the lamp (I), adjust the lamp
to the position you want, and re-tighten the thumb
screws.
2. For wall hanging, the back of your HappyLight has
two openings designed to receive screw heads (J).
Remove the base by unscrewing the two blue thumb
screws on the back of the unit. Store the base and
thumb screws. Drill two holes, level and 3½" (9cm)
apart at the location you desire, install the screws,
hang the lamp and plug it in. Install the screws into
studs or use screw anchors as required.
This product contains magnets. If you have
C
9
E
H
15º 15º
I
D
F
2
G
1
J