Dorgard DG1328-A01 Manuel D'installation Et Mode D'emploi page 15

Beep and LED Messages Explained
Beep / Flash Sequence
During standard operation
LoHi – LoHI – LoHi – LoHi – LoHi – LoHi –LoHi – LoHi
*--------*--------*--------*--------*--------*--------*--------*
Tone and flash sequence Is followed by the sound
of the motor driving
Error Modes
Lo – (2secs) – Lo – (2secs) – Lo – (2secs) – etc
*----------*----------*----------*----------*----------etc
HiHiLo.....................
* * *........................
HiHiHiHiLoLoLoLo---(4secs)---
HiHiHiHiLoLoLoLo---(4secs)---etc
HiLoLoLo---(4secs)---HiLoLoLo---(4secs)---etc
* * * * -------(4secs)--- * * * * -------(4secs)--- etc
HiLo-------(17mins)------HiLo------(17mins)------etc
(Dorgard will repeat HiLo 8 times after 68mins)
****--(4secs)-- ****--(4secs)-- ****--(4secs)-- etc
* LED flash
This pattern may repeat
What it means
Dorgard resetting ready
for re-activation
Indicates battery lift is not
screwed down properly
Possible fault with motor
Indicates possible plunger
movement fault
Indicates possible problem
with battery insertion
Low battery mode or
miscellaneous error
11
continued
What to do
No action required
1) Screw down battery lift
1) Check ferrule is not worn
or damaged. Replace if
necessary
2) Release tension on fixing
screws and check Dorgard
is positioned flat against
door with no obstructions
3) Recycle or if necessary,
replace batteries
Same 3 points of action
as above
Same 3 points of action
as above
Same 3 points of action
as above