Important Precautions - LG GDR-H30N Mode D'emploi

English
Troubleshooting
* When the DVD-ROM drive does not work with
the hard disk drive in primary IDE channel.
(SOLUTION)
1. Check the DVD-ROM drive Master/Slave
Jumper setting.
The DVD-ROM drive should be set to the
Slave mode if it is on the same IDE cable as
your Hard Drive that is set to the Primary
Master mode.
2. Check to be sure your hard disk Interface
type is IDE type.
3. Check your hard disk Master/Slave Jumper
setting. Some old-version IDE type hard
disks were set to Master Only mode.
In that case, contact your hard disk company
and change your hard disk jumper setting to
master mode.
4. If the DVD-ROM drive does not work with
above methods, you may need a secondary
IDE card.
If you use the secondary IDE card, you
should set the DVD-ROM drive jumper to the
master mode if the DVD-ROM drive is the
first device you are connecting to the sec-
ondary IDE card.
* When the DVD-ROM drive does not install in
OS/2 warp.
(SOLUTION)
1. Select NON-LISTED IDE CD.
* DVD-ROM drive is not present in Windows
3.1 or 3.11 or DOSSHELL.
(SOLUTION)
1. When the WIN or DOSSHELL command
lines are present in your AUTOEXEC.BAT,
make sure that the MSCDEX.EXE command
line appears before the WIN or the
DOSSHELL command lines.
Please Note: Since this product supports
Region Playback Control Phase II, a certain
MPEG decoder card or Software without
regional code setting may cause this drive not
to read DVD-ROM discs.
This DVD-ROM Drive enables you to change
the regional code up to 5 times.

Important Precautions

Follow these precautions when handling the
drive or discs.
Precautions
• Please take notice that the manufacturer of
this equipment does not offer any warranty
against data loss due to inappropriate
installation or handling or direct or indirect
damages.
• Please take notice that the manufacturer will
bear no responsibility for direct or indirect
damages caused by the use of this product
or its malfunction.
• Please take notice that the manufacturer will
bear no responsibility for damage to data
caused by this product.
Installation
• Avoid placing the drive in a location subject to:
- high humidity
- high temperature
- excessive dust
- mechanical vibration
- direct sunlight
We recommend using the drive in a horizontal
or vertical position. Do not install the drive at an
angle.
Operation
• Don't move the drive suddenly from a cold
place to a warm one or raise the room tem-
perature suddenly. Condensation may occur,
causing abnormal operation.
• Make sure to remove the disc before moving
the drive. The disc may be damaged, caus-
ing data loss.
• Be careful to prevent foreign objects, such as
liquids or metal, from entering the drive. In
case a foreign object enters the drive,
please consult the dealer where the drive
was purchased.
• Don't interrupt the electric power while the
drive is operating.
• When connecting two IDE devices to the
Primary or Secondary connectors, make sure
that the two devices are not configured as
both Master, or both Slave. If they are both
set the same, Windows may fail to run or
recognize the drives.