System Requirements; Rear Panel; Supplied Accessories - LG GDR-H30N Mode D'emploi

Internal atapi (e-ide) drive
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

English
Features
E-IDE interface
Data transfer rate (DVD-ROM max-16X-
speed: 22,100KB/sec, CD-ROM max-52X-
speed : 7,800KB/sec)
Motorized tray loading system
Designed for internal mounting
Emergency eject support
Read compatible for DVD-R, DVD+R, DVD-
RW, DVD+RW & DVD-RAM discs
Supports Region playback control Phase II

System Requirements*

IBM PC AT or compatible, Pentium-266MHz
processor or higher (higher recommended).
A minimum of 64MB memory
(higher recommended).
/
"
A suitable free standard 5
internal drive
1
4
bay.
OS: Windows 2000, XP, Vista.
An existing IDE controller with an available
cable connector or a new IDE controller
(recommended with IDE PIO Mode 4 capa-
bility) that you will need to install.
* Please note: Certain software (i.e. particularly
those including Video playback) may require a
considerably increased specification PC to
give acceptable results. While this DVD-ROM
drive can read DVD-video discs, decoding
them to display on your pc's monitor requires
separate MPEG decoding that is done by
separate hardware (either an MPEG decoder
card or MPEG decoding done by your video
card), or separate software that you install to
do MPEG decoding. These items are sepa-
rate and are not included with this DVD-ROM
drive.
Location and Function of
Controls
A
Front Panel
1. Disc Tray
2. Drive activity indicator
3. Emergency Eject Hole
4. Stop/Eject Button

Rear Panel

1. Digital Audio Output Connector
This connector is not supported.
2. Analog Audio Output Connector
3. Jumper Connector
This jumper determines whether the drive is
configured as a master or slave. Changing
the master-slave configuration takes effect
after power-on reset.
4. IDE Interface Connector
Connect to the IDE (Integrated Device
Electronics) Interface using a 40-pin flat IDE
cable.
NOTE : Do not connect or disconnect the
cable when the power is on, as this could
cause a short circuit and damage the sys-
tem. Always turn the power OFF when con-
necting or disconnecting the cable.
5. Power Connector

Supplied Accessories

z
z Owner's Manual
z
z Screw (4 pieces)
z
z MPEG-2 software (Power DVD)

Publicité

Table des Matières
loading

Table des Matières