Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
In the following, an example will show
how you can program the automatic
search timers for series recording.
Open the EPG by pressing the green
button on the remote control. As an
alternative, you can access the EPG
by the main menu -> 3 EPG Service
-> 1 EPG Standard.
In the EPG, mark the program
whose episodes you want to record
automatically.
Press D on the remote control to
open the command menu for the
program marked in the EPG.
Select the command „Create 1st
search timer".
Set the entry „Use as search timer"
to „Yes".
Specify the desired options for
the series recording and save your
entries then by pressing „OK".
Options for the series recording
Series recording
Choose „Yes" to save all episodes of a
series in an own sub-directory.
The ReelBox automatically creates
a subdirectory with the name of the
series.
Delete recording after ... days
Enter any value to have the recording
deleted after the respective number of
days.
Ignore repetitions
Choose „Yes" to prevent the recording
of a repetition of the same episode.
Priority
In case there are conflicts because of
parallel programmed timers because
there are not enough tuners available
for the recording, timers with higher
priority are preferred.
Operation
Lifespan
At a preset value of „99" the
recordings are never deleted
automatically. In case the ReelBox
needs space for new recording,
existing recordings are deleted
automatically if they have a value of
less than „99". The number specifies
for how long (in days) a recording
has to be on the hard disk at least
before it can be deleted automatically.
Time buffer at start (min)
Specifies how many minutes
before the start of a program the
recording should be started (to even
out program shifts).
Time buffer at end (min)
Specifies how many minutes after the
end of a program the recording should
continue (to even out program shifts).
GB
43
Publicité
Table des Matières
