Table des Matières
Publicité
200 kA/500 V
When protected by:
Non Semiconduc-
tor Fuses (currents
Model
are maximum va-
PZM2XA-A150-
D03-00 – When
installed with
PHC22A-
A110M1-...A-00/..
50 A/600 V
PZM2XA-A150-
D03-00 – When
installed with
PHC22A-
A150M1-...A-00/..
1) Drives employing Type E Combination Motor Controller model MS132-16, -25, -32 must be installed with Current Limiter Series
S803W-SCLxxx-SR manufactured by ABB, otherwise SCCR rated 30 kA/480 Vrms.
6.4.4
Motor overload protection
The units are provided with load and speed-sensitive overload protection and thermal
memory retention upon shutdown or power loss. The trip current is adjusted to 150 %
of the rated motor current.
6.4.5
Ambient temperature
The units are suitable for an ambient temperature of 40 °C, max. 60 °C with derated
output current. To determine the output current rating at temperatures higher than
40 °C, the output current should be derated 3% per °C between 40 °C and 60 °C.
REMARQUE
•
•
6.4.6
Wiring diagrams
For wiring diagrams, refer to the MOVIPRO
installation".
Three Phase 380 V – 500 V Voltage Range
SCCR:
SCCR:
200 kA/500 V
When protected by:
Inverse-Time Cir-
cuit Breaker
lues)
50 A max/500 V min
Use only tested units with a limited output voltage (V
output current (I
= 8 A) as an external DC 24 V voltage source.
max
UL certification does not apply to operation in voltage supply systems with a non-
grounded star point (IT systems).
Installation électrique
SCCR: 65 kA/480 V
When protected
1)
by:
Type E Combinationen Motor Controller
ABB, Model
MS132‑25 Ra-
ted 480 V, 15 HP
ABB, Model
MS132‑32 Ra-
ted 480 V, 20 HP
®
operating instructions, chapter "Electrical
Notice d'exploitation – MOVIPRO
Installation conforme à UL
SCCR: 65 kA/460 V
When protected by:
Rockwell Automa-
tion, Model
140M‑F8E-C25 Ra-
ted 460 V, 20 HP
Rockwell Automa-
tion, Model
140M‑F8E-C32 Ra-
ted 460 V, 25 HP
= DC 30 V) and limited
max
®
PHC2.A-A..M1-..2A-C5
6
51
Publicité
Table des Matières
