Model Numbers; Rating Label; Regulatory / Code Requirements; Important Notes - hestan KMWR30 Manuel D'installation

MODEL NUMBERS

MODEL NO.
KMWR30
EN
All units 115 VAC 60 Hz

RATING LABEL

The rating plate includes model and serial number. Open the Drawer Microwave fully. The label is
beyond the back wall of the drawer facing up from the bottom surface.
If service is necessary, contact Hestan
Customer Care with the model and serial
number information shown on the label.

REGULATORY / CODE REQUIREMENTS

Installation of this cooking appliance must be made in accordance with local codes. In the absence
of local codes, this unit should be installed in accordance with the National Electrical Code and
local codes.
This appliance must be electrically grounded in accordance with local codes or in the absence of
local codes with the National Electrical Code ANSI/NFPA 70, or Canadian Electrical code CSA
C22.1.

IMPORTANT NOTES

UNPACKING YOUR DRAWER MICROWAVE UNPACKING YOUR DRAWER MICROWAVE
• Remove all packing materials from inside the Drawer
Microwave. DO NOT REMOVE THE WAVEGUIDE COVER,
which is located on the top of the Drawer Microwave.
• Remove the feature sticker, if there is one. Check the drawer
for any damage, such as misaligned or bent drawer, damaged
drawer seals and sealing surfaces, broken or loose Drawer
Microwave guides and dents inside the cavity or on the front
side of the drawer. If there is any damage, do not operate
the Drawer Microwave and contact your dealer or a HESTAN
AUTHORIZED SERVICER.
IMPORTANT NOTES TO THE INSTALLER IMPORTANT NOTES TO THE INSTALLER
• Read all of the Installation Manual before installing the Drawer
Microwave.
• Remove all packing material before connecting the electrical
supply.
• Observe all governing codes and ordinances.
BE SURE TO LEAVE THESE INSTRUCTIONS WITH THE CONSUMER.
2
©2020 Hestan Commercial Corporation
DESCRIPTION
30" Drawer Microwave
CIRCUIT BREAKER
15 Amps
TYPICAL RATING LABEL
Sealing
surface
Waveguide
cover
Hestan Commercial Corporation
3375 E. La Palma Ave
Anaheim, CA 92806
Sealing
surface
Oven
cavity