Installation Steps - hestan KMWR30 Manuel D'installation

INSTALLATION STEPS

ANTI-TIP BLOCK ANTI-TIP BLOCK
To reduce the risk of tipping of the drawer, the Anti-Tip block must be properly installed. It must
EN
be located 14-13/16 in. [37.6 cm] above the floor on which the Drawer Microwave will sit. The
6 in. [15.2 cm] Anti-Tip block must be provided by the installer. See the figures for necessary
dimensions. The Anti-Tip block prevents serious injury that might result from spilled hot liquids.
If the Drawer Microwave is ever moved to a different location, the Anti-Tip block must also be
moved and installed. When installed to the wall, make sure that the screws completely penetrate
the dry wall and are secured in wood or metal so that the block is totally stable. When fastening,
be sure that the screws do not penetrate electrical wiring or plumbing.
ELECTRICAL CONNECTION ELECTRICAL
The appliance requires a 120 volt, 60 Hz, AC only, 15 amp or more
protected electrical supply. It is recommended that a separate circuit
serving only this appliance be provided.
The appliance is equipped with a 3-prong grounding plug. It must
be plugged into a wall receptacle that is properly installed and
grounded. Should you only have a 2-prong outlet, have a qualified
electrician install a correct wall receptacle. Do not cut or remove
the grounding prong from this plug.
Note: If you have any questions about the grounding or electrical
instructions, consult a qualified electrician or service person.
GROUNDING INSTRUCTIONS GROUNDING INSTRUCTIONS
This appliance must be grounded. The Drawer Microwave is equipped with a cord having a
grounding wire with a grounding plug. It must be plugged into a wall receptacle that is properly
installed and grounded in accordance with the National Electrical Code and local codes and
ordinances. In the event of an electrical short circuit, grounding reduces risk of electric shock by
providing an escape wire for the electric current.
Improper use of the grounding plug can result in a risk of electric shock.
EXTENSION CORD. IF THE POWER SUPPLY CORD IS TOO SHORT, HAVE A QUALIFIED EXTENSION CORD. IF THE POWER SUPPLY CORD IS TOO SHORT, HAVE A QUALIFIED
ELECTRICIAN OR SERVICEMAN INSTALL AN OUTLET NEAR THE APPLIANCE. ELECTRICIAN OR SERVICEMAN INSTALL AN OUTLET NEAR THE APPLIANCE.
FLUSH MOUNTING FLUSH MOUNTING
For flush mount installation, mount and secure the deflector vent. See instructions on previous
pages.
PLACING DRAWER PLACING DRAWER
1. Place the drawer adjacent to the wall or cabinet opening. Plug the power supply cord into the
electrical outlet.
2. Carefully guide the drawer into the prepared opening. Avoid pinching the cord between the
oven and the wall.
3. Slide the drawer all the way until the mounting flange is flush with the face of the cabinet.
See Figure 10.
4. Open the drawer. Using the 4 holes on the drawer as a template, pre-drill the cabinet using a
1/16" [1.60 mm] bit.
5. Secure the drawer with the 4 screws supplied.
10
©2020 Hestan Commercial Corporation
CONNECTION
Correct Installation
3-Prong plug
Grounding prong
3-Prong receptacle
Grounded receptacle box
DO NOT USE AN DO NOT USE AN