Get Started; Insert The Sim Card And Battery; Remove The Sim Card; Charge The Battery - Nokia 1661 Guide D'utilisation

2. Get started

Insert the SIM card and battery

This phone is intended for use with the BL-4C battery.
Always switch the device off and disconnect the charger before removing the battery.
1. Slide the back cover downwards (1), and remove it.
2. Lift the battery, and remove it (2).
3. Insert the SIM card (3). Ensure that the gold-coloured contact area is facing down
and the bevelled corner of the SIM card is slid in next.
4. Replace the battery and back cover (4, 5).

Remove the SIM card

Press the release spring (1), and slide out the SIM card (2).

Charge the battery

Your battery has been partially charged at the factory. If the device indicates a low
charge, do the following:
1. Connect the charger to a wall outlet.
2. Connect the charger to the device.
3. When the device indicates a full charge, disconnect the charger
from the device, then from the wall outlet.
Tip: To save energy, unplug the charger when the battery is fully charged.
You do not need to charge the battery for a specific length of time, and you can use the
device while it is charging. If the battery is completely discharged, it may take several
minutes before the charging indicator appears on the display or before any calls can be
made.
6 © 2009 Nokia. All rights reserved.