Data Recovering With The Ps Programmer - Alcad 905-TO Serie Manuel D'installation Et Programmation

34 - ENG
By selecting
Read Serial Number
press the T key to obtain the product code (
date (
24/02/05
) in order to update the firmware.
0006857
Once the transmodulator has been programmed, the Programming Mode
has to be disabled by switching OFF the 'Program' switch. The
'Programming' indicator turns off. The programming indicator will turn off,
the screen of the level meter will come black and after a few seconds the
picture of the selected TV program will be on screen.
8.

DATA RECOVERING WITH THE PS PROGRAMMER

Aiming the transmodulator, press the F and READ keys, and
will be displayed on the screen. All the data programmed in the
transmodulator will be read.
While reading, the program led of the transmodulator will blink; the
transmodulator must not receive other transmissions at the same time.
Keep the PS programmer aimed at the receiver until the
message is deleted from the screen.
To check the recovered data, select the function with the cursor
and the data will be displayed in the PS programmer screen.
Installation and programming manual
PARAMETERS :
OUT.CH : C21 BG
SUBTITLES : ( 2 )
INP.CH : C63 BG
OFFSET : Aut:0
OFF
BW : 8 MHz
01 - English - - - - - - - - - - TTX - - - - - Normal - - -
02 - English - - - - - - - - - DVB - - - - - Normal - - -
HW: 1.00 FW: 1.00
BER : 5 . 7 E - 3
Fig. 9 - Subtitles
), and the address of the module (
PROGRAMS : (6)
01 - FTA - LA 1 - - - - - - - - - - TV
02 - FTA - LA 2 - - - - - - - - - - TV
03 - FTA - 24h - - - - - - - - - - - TV
04 - FTA - Clan - - - - - - - - - - TV
AUDIO : (1)
DUAL A - B
01 - Spanish
in the PS programmer and
9050066
), manufacturing
S/N 002-
Read...
Read...
and