Sending Data To The To Transmodulator - Alcad 905-TO Serie Manuel D'installation Et Programmation

DATA
Standard
Output frequency 47..862 MHz
Input frequency
Input Offset
Bandwidth
Output format
Channel or
frequency
SCREEN
Data error
Reading error An error occurred during the READ function.
5.

SENDING DATA TO THE TO TRANSMODULATOR

5.1 Programming Mode
For a transmodulator to be programmed, the 'Program' switch (26) must be
switched ON; as this is done, the 'Programming' indicator turns on. While
the indicator is lit, the transmodulator is ready to receive data from the PS
programmer.
Serie 905-TO
VALUE
B/G stereo
I mono
D/K stereo
47..862 MHz
-3/6, -2/6, -1/6, Auto Input frequency setting.
+1/6, +2/6, +3/6 MHz
6, 7, 8 MHz
Letter box 4:3
Pan & scan 4:3
Full screen 16:9
Channel /
Frequency
Tab. 3 - Range of values
DESCRIPTION
The data selected does not belong to the range of
values indicated in table 3.
Tab. 4 - Warnings
DESCRIPTION
Possible standards.
Output frequency.
Input frequency.
COFDM bandwidth setting.
4:3 (with horizontal bars at the top
and bottom of the screen in 16:9)
4:3 (with the sides of the image cut
off in 16:9). Except in the
models: TO-551/543/544.
16:9
Programming the output by channel
or by frequency.
ENG - 29