Removing The Door - LG SIGNATURE LSR100 Manuel Du Propriétaire

Removing the Door

When it is necessary to move the appliance
through a narrow opening, removing the doors is
the recommended procedure.
WARNING
• Disconnect the power cord, house fuse or
circuit breaker before installing or service the
appliance. Failure to follow these instructions
may result in death, fire or electric shock.
If your entrance door is too narrow for the
appliance to pass through, remove the appliance
doors and pass the appliance laterally.
[The Left Fridge Door]
1
The water supply is connected to the
upper right part of the rear surface of the
refrigerator. Remove the ring in the joint
area. Hold the water supply connection and
gently push the collet to detach the water
supply line as shown in (1).
collet
NOTE
• Detaching the water supply is only necessary
when detaching the left refrigerator door.
2
Remove the screws from the hinge cover
at the top of the refrigerator. Lift the hook
(not visible), located on the side of the
cover at the bottom edge, with a flat-head
screwdriver.
16
3
Remove the cover and pull out the tube (1).
Disconnect all wire harnesses (2).
4
Rotate the hinge lever counterclockwise (1).
Lift the top hinge (2) free of the hinge lever
latch.
• When lifting the hinge free of the latch, be
careful that the door does not fall forward.
(1)
5
Remove the hinge lever by tapping the end
of it toward the outside edge of the cabinet.
• When lifting the hinge free of the latch, be
careful that the door does not fall forward.
Hinge Lever
Latch
(1)
(2)
CAUTION
CAUTION
EN