Publicité
Les langues disponibles
Les langues disponibles
- Out of direct sunlight
- Do not store in plastic bags as humidity may
form.
Disposal:
- Electric and electronic waste may contain
substances that are dangerous for the environ-
ment and for human health. For this reason they
must never be disposed of together with domestic
waste, but collected separately in specific collec-
tion centres or returned to the retailer when similar
new equipment has been purchased. The illegal
disposal of such equipment may result in prosecu-
tion to the full extent of the law.
- Do not dispose of used oil with domestic waste,
but take it to the special Collection Centres.
Troubleshooting
Problem
The chain saw does not start
The chain saw works at inter-
vals, turning on and off
The chain does not turn
The chain and bar overheat
Chain is dry
The chain brake does not work
The chain saw does not cut well,
blocks, or makes banging noise
An oil stain forms under the
chain saw
The bar loosens
CS355EA_IM (New).indd 11
Probable cause
Lack of power
Defective power cable
Defective On/off switch
Loosened contact in the chain
saw
Defective power cable
Check that the front hand guard
is not lowered
Insufficient oil in the tank
The chain is too tight
Clogged air release on cap
Oil nozzle or channel clogged
Insufficient oil in the tank
Defective hand guard mecha-
nism
Chain is loose
Chain is worn
Defective chain
The chain saw was not cleaned
and the sawdust releases the oil
accumulated during cutting
The wheel was fixed inad-
equately
Solution
Check the powe supply
Check, replace
Contact customer service centre
Contact customer service centre
Replace
Push the front hand guard
towards the motor
Fill
Loosen the chain
Clear the hole in the cap
Clean
Fill with oil
Contact customer service centre
Adjust the chain tension
Sharpen or replace
Replace
Clean the saw and remove the
sawdust from the housing
Check that the wheel has been
tightened firmly
2019-03-01 08:53:55 AM
Publicité
