Fein RS10-70E Mode D'emploi page 14

OBJ_BUCH-0000000020-001.book Page 14 Thursday, December 9, 2010 8:48 AM
en
14
Operating instructions.
The self-start lock prevents the power tool
from automatically restarting again, even after
a brief interruption of the power supply, e. g.,
from a pulled mains plug.
Guide the machine with the sanding belt
against the pipe subject to sanding until the
pipe is covered about halfway by the sanding
belt.
Sand the pipe uniformly applying a continu-
ous length motion.
Always hold the machine with both hands and
at a right angle to the pipe (also applies for
pipe arcs).