Fein RS10-70E Mode D'emploi page 11

OBJ_BUCH-0000000020-001.book Page 11 Thursday, December 9, 2010 8:48 AM
Assembly instructions.
Before mounting or replacing application tools or accessories, pull the power
WARNING
plug. This preventive safety measure rules out the danger of injuries through
accidental starting of the power tool.
Mounting the sanding belt (Fig. 3 – 4).
1. Position the sanding belt around the drive
roller and the deflection roller on the
fixed extension arm.
2. Push the swivelling extension arm inward
and position the sanding belt onto its
deflection roller.
3. Firmly push the swivelling extension arm
outward to tension the sanding belt and
make it ready for operation.
Carry out a test run for approx. 20 sec-
onds with the new sanding belt.
en
11