Lanaform Java Mode D'emploi page 6

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 9
INSTRUCTIONS FOR USE
Features:
• Ceramic cover;
• Total capacity of 100 ml;
• Up to 7 hours of continuous diffusion;
• Input power: AC 100-240V, 50-60Hz;
• Output power: DC24V 500mA;
• Lifespan of the ceramic disc: +/- 3,000 hours.
Functionalities:
• Essential oil diffuser;
• Eliminates electrostatic charges;
• Improves ambient air quality.
Instructions for use:
• Place the Java diffuser in the room half an hour before turning it on to allow it to adjust to the room temperature.
• Check that the diffuser is clean.
• Insert the end of the adapter in the DC-jack socket located under the base of the diffuser. (12)
• Place the diffuser on a flat, stable surface, keeping it away from the edge. (13)
• Remove the outer ceramic cover from the base of the diffuser and then remove the inner plastic cover from the diffuser. (14)
Note: as the cover is made of ceramic it can break easily.
• Fill the reservoir with no more than 100 ml of mineral water and ensure the water level is no higher than the line shown on the inside of the
base. (The temperature of the water should not exceed 40°C). (15)
• Pour a few (2-5) drops of essential oil into the reservoir. (16)
• Replace the ceramic cover on the filled water reservoir. Take care when handling. The ceramic cover is simply placed on the plastic base, it is not
secured. Make sure there is no space between the base of the diffuser and the ceramic cover. (17)
• With dry hands, connect the power supply plug. (18)
• Press the ON/OFF button on the base of the diffuser to switch it on. The mist it diffuses creates an ambiance that encourages relaxation. (19)
• The diffuser has several functions:
• Press once to start diffusion and atmospheric light effects. (20)
• Press a second time to set your preferred atmospheric colour. (21)
• Press a third time to start the cyclical diffusion. The device will run with the atmospheric light effects for 30 seconds and will then stop for
30 seconds until the water reservoir is empty. (22)
• Press a fourth time to stop the atmospheric lights. The diffuser will continue to diffuse continuously. (23)
• Press a fifth time to switch the diffuser off. (24)
When the water level in the reservoir is too low or empty, the device will stop automatically. If this happens, refill the water following the steps in
the instructions for use to restore normal operation.
NOTE: Use the spout to empty the water from the reservoir out of the side opposite the exhaust vent. Never empty the water through
the exhaust vent. This would damage the diffuser. (25)
N.B.: EVEN THOUGH THERE IS A SAFETY DEVICE THAT STOPS THE TRANSDUCER WORKING, DO NOT LEAVE THE DEVICE CONNECTED WHEN YOU ARE
NOT USING IT.
ADDITIONAL INFORMATION RELATING TO THE USE OF ESSENTIAL OILS
• Before using essential oils, please check the harmful effects that use of these products may have on your health.
• Always choose quality essential oils that are pure, 100% natural and intended for diffusion. Use them in moderation and with care. Follow the
instructions and warnings stated on the packaging of the essential oils, in particular noting that:
• Pregnant women, people with epilepsy, asthmatics and people who suffer from allergies, and those with heart problems or serious
illnesses should not use essential oils.
• Essential oils should be used only for periods not exceeding 10 minutes in a baby's room (under 3 years old) and only when the baby is not
actually in the room.
• Make sure that children and minors do not play with or use the device.
EN
Java
7

Publicité

Table des Matières
loading

Table des Matières