Mounting Of Punching Tools; Mode Of Operation: Perforating; Maintenance / Cleaning; Troubleshooting And Service - hawa 2671 Mode D'emploi

Operating instructions Section shears 2671

5.2 Mounting of punching tools

Press rubber wiper (1) with round hole onto punch (3). Insert and clamp (9) die (2).
Insert punch (3) into support and secure it with pressure plate (4+5).
When punching oblong holes, please check if die is mounted in a vertical or horizontal position.
30x15x1,5 C 30
DIN EN 50024
32x15x1,5 G32
DIN EN 50035
Pressure plate
11
5

5.3 Mode of operation: perforating

Install punch tool. Position suitable rail guide (6) and secure it (7). Insert rail to the fixed (8) or adjustable stop (optional accessory).
Operate hand lever or hydraulic pump for perforating. Remove perforated rail (10).

6. Maintenance / Cleaning

Use only original parts from häwa GmbH for replacement or exchange.
• At regular intervals the unit should be cleaned and lubricated at the grease nipples
• Before each use, the unit should undergo an optical evaluation, incl. the hydraulic hose and the drive system
• Oily rugs and hydraulic oil have to be treated as hazardous waste

7. Troubleshooting and service

If you experience a break-down of the equipment please contact your local sales office or the manufacturer. Here you will receive help and hints to do
smaller repair work yourself. If a complex repair is necessary, this must be performed by our factory-service, as häwa will not assume any liability for
improper repairs and resulting consequential damages.
8
35x15x2,3
DIN EN 50022
35x15x1,5
DIN 46277
35x75x1
DIN EN 50022
6
10
Punch
3
4
90 °
1
7
2
Rubber wiper
8
Fixed stop
9,0 mm
9