Punching Of Larger Cut-Outs; Tool And Material Dimensions; Maintenance / Troubleshooting / Service - hawa Maxi-Press 500 Mode D'emploi

Operating instructions Maxi-Press 500

5.3 Punching of larger cut-outs

To punch larger square or rectangular cut-outs, the use of 0.87" or 1.00"square punches in sequential operations is recommended.
When nibbling, please ensure that the punch always and completely punches through the sheet steel.

5.4 Tool and material dimensions

Permissible punch sizes:
Round: from ø 0.16" up to ø 2.36"
Square: from 0.35" up tp 1.81"
Max. sheet metal thicknesses:
Sheet steel ST37 11 ga
Stainless steel 14 ga
Aluminum 9 ga
dependends on punch size
Electro-hydraulic pump

6. Maintenance / Troubleshooting / Service

Use only original parts from häwa GmbH for replacement or exchange.
Maintenance
• The Maxi-Press 500 mostly works maintenance-free
• At regular intervals the unit should be cleaned, and zinc-plated parts should be lubricated
• Visual and functional inspection of the equipment should be performed weekly
• Oily rugs and hydraulic oil have to be treated as hazardous waste
Troubleshooting and service
If you experience a break-down of the equipment please contact your local sales office or the manufacturer. Here you will receive help and hints to do
smaller repair work yourself. If a complex repair is necessary, this must be performed by our factory-service, as häwa will not assume any liability for
improper repairs and resulting consequential damages.
14
Foot switch