Electrical Components - fluidra PRO 30889 Manuel D'installation Et D'entretien

USE:
• It is imperative to ensure that the intake ports are not blocked.
• It is recommended to stop filtering while performing maintenance of the filtration system.
• The filter should be monitored regularly to check it is not clogged.
• Prevent access to the pool in the case of damage to the filtration system(s).

7. ELECTRICAL COMPONENTS

To guarantee electrical safety, the equipment is provided with an electrical unit that is protected against the inlet of water. If a cable or any of
the components are damaged, the whole electrical unit should be changed.
None of the components of this electrical unit should be handled, as it would affect the safety of the equipment.
REPLACING THE ELECTRICAL UNIT
If a cable or a component of the electrical unit is damaged, proceed as follows:
• Disconnect the apparatus from the mains.
• Unscrew the 3 screws of the bottom cover and remove it.
• Unscrew the 3 screws that hold the motor and remove the electric/motor unit.
• Place the new electric/motor unit by tightening the 3 screws to the body of the skimmer and place the bottom cover by tightening the 3
corresponding screws
8. WINTER MONTHS - MAINTENANCE WHEN OUT OF USE
To preserve the equipment properly during the winter months or when it is not used for long period of time, proceed as follows:
Empty the water from the pool until 4 cm. under the lower edge of the backpack skimmer frame (No. 9 Fig 3)
Insert the O-ring (Fig. 1) in the winter plug (No. 14 Fig. 1) and screw the plug to the return nozzle from inside the pool, using the spanner (No.
13 Fig. 1). Remove the cartridge, dry it and store it.
It is recommended to use this occasion to visually check the condition of the cable and other electrical components and replace if necessary.
To do this, see section ELECTRICAL COMPONENTS.
PROBLEMS
The backpack skimmer does not filter, but
does put water in the swimming pool.
The filter does not let water flow in the return
nozzle
If you cannot solve the problem, contact the swimming pool manufacturer at the number indicated in the instructions.
CAUSE
The cartridge is not positioned correctly.
The cartridge is worn through use
The filter is dirty through use
Faulty electrical connection
5
SOLUTION
Position it correctly and screw into place
Replace with a new one
Clean the cartridge as indicated in section
6.1. Cleaning the cartridge.
Check the connection
Check the filter cable