Dexter 350OS2.5 Manuel D'instructions page 127

Table des Matières

To remove the sanding paper, peel it away from the base.

Select the required grade of sanding paper.

Ordinary (non Hook & Loop type) sanding paper can also be used.

Remove any dust or debris from the hook and loop of the base.

Release the sandpaper clamp from both sides of the sander.

To attach hook & loop type sanding paper simply align the holes in the sanding paper

Insert the end of the sandpaper under one clamp and pull the paper tight over the base

ensuring the holes align with those in the base and then clamp the other side.

To remove the sanding paper, peel it away from the base.

The sanding paper should be kept tightly clamped over the base, otherwise there could

Ordinary (non Hook & Loop type) sanding paper can also be used.

be excessive wear of the base material.

Release the sandpaper clamp from both sides of the sander.

Insert the end of the sandpaper under one clamp and pull the paper tight over the base

WARNING: Do not continue to use the sander with a sanding paper

ensuring the holes align with those in the base and then clamp the other side.

that is overworn or damaged.

The sanding paper should be kept tightly clamped over the base, otherwise there could

WARNING: Do not use the same sanding paper for wood and metal.

be excessive wear of the base material.

Metal particles become embedded in the sanding paper and will

scour a wooden surface.

WARNING: Do not continue to use the sander with a sanding paper

WARNING: Take care to regularly clean out the build up of dust on the