Cold Weather Operation; Charging The Battery Pack - GreenWorks BAM704 Guide D'utilisation

Batterie multi-tension 24v - 48v
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

OPERATION
BATTERY PROTECTION FEATURES
GW 24V-48V lithium-ion battery packs are designed with features that protect the lithium-ion cells
and maximize battery life.
If the tool stops during use, release the trigger to reset and resume operation. If the tool still does
not work, the battery needs to be recharged.

COLD WEATHER OPERATION

The lithium-ion battery pack can be used in temperatures down to -14°C (6.8°F). Put the battery
pack on a tool and use the tool in a light duty application. After about a minute, the pack will warm
up and begin operating normally.

CHARGING THE BATTERY PACK

Battery packs are shipped in a low charge. Therefore, you should charge your battery before it's first
use. If the charger does not charge the battery pack under normal circumstances, return both the
battery pack and charger to your nearest Authorized Service Center for service.
• Charge the battery pack only with the recommended charger.
• Connect the charger to a power supply. For approved power sources, refer to the operator's
manual of the charger.
• Make sure the battery pack is secured in the charger before beginning operation.
• Press down on the battery pack to ensure the contacts on the battery pack engage properly with
the contacts in the charger.
• The battery pack may become slightly warm to the touch while charging. This is normal and does
not indicate a problem.
• Do not place the charger and battery pack in an area of extreme heat or cold. They will work best
at normal room temperature.
• When batteries become fully charged, unplug the charger from the power supply and remove the
battery pack.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions:
1. This device may not cause harmful interference.
2. This device must accept any interference received, including interference that may cause
undesired operation.
C A U T I O N
The user is cautioned that changes or modifications not expressly approved by the party responsible
for compliance could void the user's authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio frequency energy and,
if not installed and used in accordance with the instructions, may cause harmful interference to
8

Publicité

Table des Matières

Dépannage

loading

Ce manuel est également adapté pour:

Bam706

Table des Matières