Krups IP-COM M50 Mode D'emploi page 8

5
6
7
• You can now plug your citrus press into a power socket.
8
IV - THE APPLIANCE CAN NOW BE USED IN TWO WAYS
Operating the press using the control lever
• Raise the control lever (A).
• Place a glass under the pouring spout (G1).
• Cut your citrus fruit in half. (Try to make them as equal in size as
• Place your fruit on the cone (E), applying gentle pressure on it.
• Turn the on/off switch / selector knob (J) to the "lever" position.
• Lower the lever (A). The citrus press will start working
• Maintain constant pressure.
• Remove your glass.
Pressing by hand
• Lift the lever (A) to the raised position.
• Place a glass under the pouring spout (G1).
• Cut your citrus fruit in half. (Try to make them as equal in size as
• Turn the on/off switch / selector knob (J) to the "hand" position.
• With your hand, press the fruit onto the cone (E) and maintain
• Remove your glass.
1. Fit the bowl (G) with the pouring spout (G1) positioned slightly to the left, then
push it downwards.
2. Lock the bowl into place by rotating it clockwise.
• To unlock the bowl, rotate it anti-clockwise and then lift gently upwards.
• Place the pulp filter (F) inside the bowl (G).
• Then, slide the cone (E) onto the axle.
• Ensure that the on/off switch / selector knob (J) is in the OFF position before
plugging in your citrus press to the electrical supply.
possible.)
automatically.
possible.)
The cone will start to rotate.
the pressure.
5