Attach Work Clamp; Install Dust Collection Bag; Install Batteries For Laser - ShopMaster DELTA Série Manuel D'utilisation

ATTACH WORK CLAMP

The work clamp secures the workpiece to the fence to
provide more stability and keeps the workpiece from
creeping toward the saw blade. To install the work clamp,
see Figure 7 and do the following:
1. Place the clamp shaft (A) in either hole (B) on the
mitre table base.
2. Rotate the knob (C) on the clamp clockwise to move
it in or counterclockwise to move it out as needed.

INSTALL DUST COLLECTION BAG

The tool includes a dust collection bag that attaches
over the exhaust port on the upper blade guard.
To install, slide the plastic collar (D) of the dust bag onto
the dust port (E). See Figure 8.
NOTE: To remove the dust bag for emptying, simply
reverse the above procedure.

INSTALL BATTERIES FOR LASER

1. The battery compartment (F) is located in the control
arm on the top of the saw handle.
2. Using the Phillips end of the supplied blade wrench,
remove the screw (G) securing the compartment
cover and lift off the cover.
3. Install two AAA batteries (supplied) as shown on the
diagram in the compartment.
4. Replace the cover and secure with the screw.
See Figure 9.
Laser radiation. Avoid direct eye
contact with light source.
ASSEMBLY
B
D
11
FIGURE 7
E
FIGURE 8
F
FIGURE 9
C
A
G