5. Cleaning
Warnings:
1. Do not clean the power supply with water or any liquid.
2. Do not use harsh soaps, detergents, solvents or alcohols to clean the tube.
3. Only reassemble the system when the tube is fully dry.
4. Do not use a dishwasher to clean the heated tube.
Cleaning Instructions:
1. Clean the heated breathing tube every day.
2. Press the lever and pull the connector housing to disconnect the connector lead from the
heated breathing tube connector port.
3. Wash the heated breathing tube in slightly warm, mild soapy water.
4. Rinse the tube using clean water.
5. Gently tap the connector cuff to remove the surplus of water from the connector port.
6. Hang-up the heated breathing tube with both cuffs hanging towards the floor.
7. Allow the tube to dry.
6. Operating Conditions
Ambient Temperature: 5°C – 30°C
Relative humidity: 5% – 95%
7. Storage and Transport Conditions
The device and its components should be transported and stored in their original packaging and
protected from direct sunlight and dust.
Temperature during storage and transport should not exceed 60°C or be below -20°C at a
relative humidity from 5 % to 95%.
8. Frequently Asked Questions
Question:
What happens if I connect the mask-end cuff to the humidifier and the humidifier-
end cuff to the mask?
Answer:
The Hybernite Rainout Control System will function similarly as with the correct
connection (mask-end cuff to mask and humidifier-end cuff to humidifier).
However, to achieve maximum comfort and safety always connect the tubing in
the correct direction, as instructed.
Question:
Can I use the heated tubing without connecting to the power supply?
Answer:
Yes, the tubing will act like a standard CPAP tube. However, rainout might occur.
Question:
When do I replace my Hybernite heated breathing tube?
Answer:
The heated tubing should not be used for more than 12 months.
If damaged, leaking or malfunctioning, replace your Hybernite heated tube
immediately.