Directions For Use - Hybernite Superday ROC 2300 Conseils D'utilisation

4. Directions for use

Humidification System compatibility
The Hybernite Rainout Control System consists of a heated tube and an independent power
supply.
The Hybernite heated breathing tube has standard cuffs on both the humidifier-end cuff and
mask-end cuff. As such, the Hybernite heated breathing tube can be connected to heated
humidifiers that have standard male outlet connectors.
For example: Respironics M Series Humidifier and Philips Respironics System One Humidifier
How to connect
1. Remove the packaging from the heated breathing tube.
2. Before setup, check your tubing, connector and power supply for any damage.
3. Connect the connector lead from the power supply to the connector port located in the
humidifier-end cuff.
4. Connect the heated breathing tube with the humidifier-end cuff to the outlet of the
humidifier.
5. Connect the mask-end cuff to the mask.
6. Ensure there is a flow of air through the tubing.
7. Plug the power cord plug in the wall power socket and place the power supply on the
floor.
8. Verify the power supply is functional by checking the LED indicator on the power supply.
9. Apply mask and use as directed by your physician or respiratory therapist in accordance with
the instructions in your CPAP or mask ventilator system operating manual.
How to disconnect
Press the lever and carefully pull the lead
connector to disconnect the lead connector
from the heated tube.