Salora SBO880 Guide D'utilisation page 8

Connections
Using the optical input
You will need: An audio source with an optical Audio output and a digital optical audio cable (included)
1. Connect the digital optical audio cable to the optical output on the audio source and to the
OPTICAL IN on the speaker bar.
2. Press and hold 3 seconds the POWER/SOURCE button on side panel or POWER button directly on
the remote control to switch on the unit.
3. Press the SOURCE button on your remote control repeatedly to switch to optical mode or one touch
the POWER/SOURCE button on main unit repeatedly to select the optical mode. The mode indicator
LED will turn orange.
4. Using the native controls on your connected device, make sure the audio settings are set to PCM
or optical audio and are turned on.
5. Audio from the connected audio source will now be played through the speakers.
Using the LINE IN
1. Plug one end of a 3.5mm audio input cable(included) into the LINE IN on the unit. Before
use, disconnect and cables connected to the stereo RCA inputs.
2. Plug the other end of the cable into the audio output/headphone output on an MP3 player or other
audio source.
3. Press and hold 3 seconds the POWER/SOURCE button on side panel or POWER button directly on
the remote control to switch on the unit.
4. Press the SOURCE button on your remote control repeatedly to enter LINE IN mode or one
touch the POWER/SOURCE button on the unit repeatedly to enter LINE IN mode. The mode
indicator will turn green.
5. Audio played through the connected device will now be heard through the speakers.
OPTICAL IN
DC 18V
- 7 -