Dimas PP 455E Mode D'emploi page 26

Work procedure for wall sawing
1. Scroll using the arrow keys and press OK when
"Calibrate potentiometers" is shown.
The display shows: CALIBRATE 0 0. The left-hand digit
refers to the blade motion and the right digit refers to the
trolley motion.
When the knobs are turned from the zero position the
zeros are shown and a number of >>>. The number of
arrows depends on how far the knobs are from the zero
positions.
1. Remove the knobs by unscrewing the screws located
on the side of each knob. Use an allen key.
2. Turn the shafts until only two zeros are shown on the
display.
3. Fit the knobs again.
4. Adjust the plastic washer.
5. Press OK.
6. Press the down arrow to continue to "Back to the
menu".
5 Settings PP 455E
This sub-menu contains information about the hydraulic
unit and functions for setting of units and the PIN code.
The sub-menu consists of six part menus:
1. Dimas PP 455E version
2. AM (American) units
3. Radio ID
4. ID Hydraulic unit
5. PIN code
6. Change the PIN code
1. DIMAS PP 455E version. The display shows the
version number, for example 2.0, for the software.
• Press the down arrow to continue to the next part
menu.
2. AM units. The display shows: AM units and ON or
OFF. When the function is ON American units are
used in the menu system.
• Press the down arrow to continue to the next part
menu.
3. Radio ID
In order to make radio contact with the remote control and
the hydraulic unit, an ID number must be stated. The CAN
cable must be connected between the remote control and
the hydraulic unit to change the ID number.
• Press OK when the display shows RADIOID 0 0.
The left-hand digit refers to the high byte and the right
digit refers to the low byte.
26 - English
• State, with the arrow keys, the high byte and press OK.
• State, with the arrow keys, the low byte and press OK.
• Press the down arrow to continue to the next part
menu.
From the factory the ID number is the same as the
machine number. If the remote control or the hydraulic
unit are replaced or reprogrammed, an ID number must
be stated. As a suggestion, change to the hydraulic unit's
ID number.
4. ID Hydraulic unit
The display shows the identity number for the hydraulic
unit. The identity number must be greater than 0.
• Press the down arrow to continue to the next part
menu.
5.5 PIN code
When the function is activated, a four digit PIN code is
requested each time the remote control is switched on.
The first time the code is 0000. When the wrong PIN code
is stated 4 times in succession the hydraulic unit is locked
A PUK code (provided by Dimas) must then be stated to
unlock the unit.
The display shows: PIN code and ON or OFF.
To activate or deactivate:
• Press OK to switch between ON and OFF.
6 Default setting
This function restores all the menu settings to the factory
settings. The PIN code is also restored.
The display shows: DEFAULT SETTING and ON or OFF.
OFF is shown when a change has been made that differs
from the default settings.
7 OUT Settings
This function confirms or rejects all settings made before
the operations menu is shown again.
• Press OK when the display shows OUT SETTINGS.
The display shows: SAVE? NO.
To not implement the made settings:
• Press OK.
To implement the made settings:
• Press arrow up/down to select YES.
• Press OK.
Operator's Manual PP 455E