Operations Menu - Dimas PP 455E Mode D'emploi

Work procedure for wall sawing

Operations menu

The operations menu starts after step 3 in the start menu.
All information about operations and all setting options are
accessed from this menu.
The operations menu consists of eight menus:
1a. Dimas PP-455, 1b Status
2. Water coolant ON/OFF?
3. Phase 1, Phase 2, Phase 3
4. Settings
5. Time
6. Total machine time
7. Battery status (only machines equipped with a radio)
8. Radio channel (only machines equipped with a radio)
1.a DIMAS PP-355, Start electric motor
Press the green button on the remote control to start
the electric motor.
1b. Status
Status is the main information that is always shown on
the display when the hydraulic unit with connected
machine is operational:
• STATUS OK, signifies that the unit is operational and
no warning messages have been issued.
• KV xx, where KV represents water coolant and xx ON
or OFF. What is shown depends on whether the water
coolant is switched on or off.
• yyy BAR, where yyy represents the instantaneous
operating pressure.
• When time is switched on:
mm:ss, is also shown, i.e. the time in minutes and
seconds.
2. Water coolant
Turn on and turn off the water coolant by pressing OK.
The display then shows: STATUS OK KV OFF/ON yyy
BAR. Now press arrow down to continue in the
operations menu.
20 - English
3. Phase 1, Phase 2, Phase 3
The instantaneous main voltage to the hydraulic unit is
shown under each phase name.
When the voltage becomes low, an error message is
shown on the display, see the section "Error
messages".
CAUTION
Long electrical cables with a small core cross
section can result in a voltage drop. The
hydraulic unit can then warn of a too low
voltage.
4. Settings
Via this sub-menu a number of values can be changed
to affect the hydraulic unit's characteristics.
To access the sub-menu: State the four digit PIN-code
0012 with the help of the arrow keys and the OK
button.
To save the settings; select "Save" in sub-menu 3
"OUT SETTINGS".
Refer to the "SETTINGS" section for complete
information about the setting options,
5. Time
The function is used to measure the amount of time a
job takes. The time is counted from when the saw
starts working. Select:
• ON, to enable.
• OFF, to disable.
• RESET TIME, to reset.
Quit by pressing OK. The main information "Status" is
then shown on the display.
When you select time ON (and when the hydraulic unit
is operational, see 1.b) 00:00 is also shown in the
lower right corner of the display. Press arrow down to
continue in the operations menu.
The total time that the hydraulic unit has been
operational is shown here. The time is stated in hours
and minutes (hhhh:mm).
Operator's Manual PP 455E