NEC MultiSync LCD 3735WXM Manuel D'utilisation page 2

FEDERAL COMMUNICATIONS
COMMISSION (FCC) WARNING
Instruction to Users
This equipment has been tested and found to
comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC rules.
These limits are designed to provide reasonable
protection against harmful interference in a
residential installation. This equipment generates,
uses and can radiate radio frequency energy and,
if not installed and used in accordance with the
instructions, may cause harmful interference to
radio communications. However, there is no
guarantee that interference will not occur in a
particular installation.
If this equipment does cause harmful interference
to radio and television reception, which can be
determined by turning the equipment off and on,
the user is encouraged to try to correct the
interference by one or more of the following
measures.
- Reorient or relocate the receiving antenna.
- Increase the distance between the equipment
and the receiver.
- Connect the equipment into an outlet on a
circuit different from that to which the
receiver is connected.
- Consult the dealer or an experienced radio/
TV technician for help.
This equipment has been certified to comply with
the limits for a Class B computing device, pursuant
to part 15 of the FCC rules. Only peripherals
(computer input / output devices, terminals, printers
etc.) certified to comply to the Class B limits may
be attached to this computer. Operation with non-
certified peripherals is likely to result in interference
to radio and TV reception.
Remarks
To meet FCC requirement, shielded cables are
required to connect the device to a personal
computer or other Class B certified device.
Information to Users
The unit is for office equipment use.
Any change or modifications not expressly
approved by the party responsible for compliance
could void the user's authority to operate this
equipment.
DOC NOTICE
This product conforms to Canadian Class B emissions
regulations.