GE JGP636 Instructions D'installation page 5

Installation Instructions
B
Installing the Cooktop Unit
Locate the electrical outlet
B1
and the Gas Shut Off valve
beneath the cabinet.
NEVER REUSE
OLD CONNECTORS
WHEN INSTALLING
THIS UNIT.
Install a manual shutoff valve in the gas line
in an easily accessible location outside the
cooktop. Be sure you know how and where to
shut off the gas supply to the cooktop. Install the
electrical outlet 12" below the countertop.
Protect the Surface
B2
of the Cooktop
Place a towel or tablecloth onto the countertop.
Lay the cooktop upside down onto the protected
surface.
Attach the Adhesive Strip
B3
(Glass Top Models Only)
Attach the adhesive strip around the maintop
glass as close to the edge as possible.
Cooktop
Burner
Box
Countertop
Locate The Mounting Parts
B4
Remove the hold down brackets from the
literature package.
Shut Off
Valve
Bottom of cooktop
Cloth under Cooktop
Outer edge
of glass bottom
Adhesive Strips
to outer edge
of glass
B5
Remove the screw from the side of the
cooktop. Screw the hold down bracket to the
side of the cooktop unit. Repeat for opposite
side of cooktop.
Electrical
Outlet
12" Below
Countertop
B6
Insert the cooktop centered into the cutout
opening. Make sure the front edge of the
countertop is parallel to the cooktop. Make
final check that all required clearances are met.
Once the unit is in place, screw the hold
down bracket into the cabinet sides to
secure the unit into place.
5
Attach Brackets to Cooktop
Bottom of
Cooktop
Foam Strips
Cooktop
Glass
Insert Cooktop Into Cutout
COOKTOP
Pre-drilled
hole