Installation Instructions; Important Safety Instructions; For Your Safety; Electrical Requirements - GE JGP636 Instructions D'installation

Installation Instructions

IMPORTANT SAFETY INSTRUCTIONS

For Your Safety

WARNING!!
If the information in this manual
is not followed exactly, a fire, explosion
or gas leak may result, causing property
damage, personal injury or death.
Do not store or use gasoline or other
flammable vapors and liquids in the vicinity
of this or any other appliance!
WHAT TO DO IF YOU SMELL
GAS:
STOP! STOP!
• Do not try to light any appliance. Do not touch
any electrical switch; do not use any phone in
your building.
• Immediately call your gas supplier from a
neighbor's phone. Follow the gas supplier's
instructions.
• If you cannot reach your gas supplier, call the
fire department.
Installation and service must be performed
by a qualified installer, service agency or the
gas supplier.
This cooktop has been design certified by CSA
International. You'll find safety precautions in
your Owner's Manual. Read them carefully.
• Installation of this cooktop must conform with
local codes or in the absence of local codes
with the National Fuel Gas Code, ANSI Z223.
1-Latest edition.
• Be sure your cooktop is installed properly by a
qualified installer or service technician.
• To eliminate reaching over surface burners,
cabinet storage above burner should be avoided.
• Do not install the unit near an outside door or
where a draft may affect its use.
Electrical
Requirements
This Appliance must be electrically
grounded. Check with your local codes
which apply in your area. If no local codes
apply, the National Electrical Code, ANSI/
NFPA No. 70-Latest Edition must be
followed. Write to:
National Fire Protection Association
Batterymarch Park
Quincy, MA 02269
Be sure the installation of this cooktop
in a mobile home conforms with the
Manufactured Home Construction and
Safety Standard, Title 24 CFR, Part 3280.
If this standard does not apply, you must
follow the standard for Manufactured Home
Installations, ANSI A225.1 and Manufactured
Home Installations, Sites and Communities
and ANSI/NFPA 501A or with local codes.
You can get a copy of the Federal Standard
by Writing:
Office of Mobile Home Standards
451 7th Street, S.W.
Washington, D.C. 24010
2
HUD Building