SilverCrest SWV 300 B2 Manuel D'utilisation Et Informations Sur Les Services page 151

The dual-band wifi range extender should be placed near
(approx. 2-3 metres) the wireless router the first time it is used.
Insert the dual-band wifi range extender into a socket that is always easily
accessible.
Then switch on the dual-band wifi range extender by turning the main switch
(9) to the "ON" position. The dual-band wifi range extender requires a certain
amount of time (boot time) after it is switched on before it is ready to use. The
Power/WPS LED (3) lights up permanently as soon as the booting process is
complete.
There are two different ways to configure the dual-band wifi range extender. If
your wireless router supports WPS, you can use this simple function to easily set
up the dual-band wifi range extender. If you would like to use a wireless router
without WPS, you must connect the dual band wifi range extender via network
cable or wireless network to your computer and configure it.
SilverCrest SWV 300 B2
English - 149