Technical Specifications; Operating Instructions - Flex ALC 514 Notice D'emploi

Line laser

Technical specifications

Order number
Precision
Self-levelling range
(horizontal)
Operating range (Ø)
Operating range with
RC 2 receiver (Ø)
Operating duration
(batteries)
Visible laser diode
Laser class
Weight (ALC with batteries) 1.5 kg
* depending on the ambient light

Operating instructions

Before switching on the angle
grinder
Unpack the power tool and check that the
delivery is complete and not damaged.
Before using the power tool for the first time
– Charge the battery pack,
– Insert the batteries into the receiver.
Charging the battery pack
Attention!
Use original battery set only.
Note
If the LED (4) flashes, charge the battery
pack.
n
Connect battery charger to the machine.
329.460
±3.0 mm/10 m
±3.5°
20 m*
80 m*
15 h
6 x 635 nm
2M
n
Connect the battery charger to the
power supply.
The LED (15) is lit red.
The charging time for a fully discharged
battery pack is approx. 10 hours. The LED
(15) is lit green when the machine is ready to
use but not yet fully charged. During the
charging process the power tool should be
switched off.
Mains mode
The power tool can continue to be used with
the battery charger in mains mode. To do
this, connect the battery charger as
described above.
Batteries for the receiver
(Accessories)
Required batteries:
– 1 x 9 V-unit.
n
Remove the battery compartment cover
from the receiver.
n
Insert the 9 V unit as indicated.
n
Close the battery compartment cover.
Positioning the machine
Note
For optimum results it is recommended to
attach the machine to a tripod.
The machine can be mounted directly on
a standard tripod with the
5
/ " thread.
8
15