Samsung NX36R9966P Serie Manuel D'installation page 28

Installation instructions
Locking screw
Adjustment air shutter (Bake Burner)
28 English
Install_NX36R9966PS_DG68-01106A-02_EN.indd 28
5. Loose Locking screw of Broil Burner
and, adjust air shutter.
1. Remove 2 screws of Cavity Floor and
remove Cavity Floor.
2. Remove 2 screws of Bracket Base and
remove Bracket Base.
3. Loose Locking screw of Bake Burner
and, adjust air shutter.
To adjust the shutter, loosen the locking
screw and rotate the shutter towards the
open or closed position as needed. If flames
are lifting off the burner ports, gradually
reduce the air shutter opening until the
Locking screw
flames are stabilized.
If flames are too yellow and/or too large,
gradually increase the air shutter opening
until the flames have approximately a 1 in
blue cone.
NOTE
If the range is set up for natural gas, the
flames should burn with minimal yellow
tipping. If the range is set up for LP gas,
small yellow tips at the end of the cones are
normal.
After the flames are adjusted properly, shut
off the oven, retighten the locking screws,
replace the oven bottom and racks, and
close the oven door.
Locking screw
7/18/2019 6:06:07 PM