Remington REVEAL CR4000 Mode D'emploi page 5

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 15
ENGLISH
, HOW TO USE
Clean and dry the area you plan to treat.
, Tip: Place a towel under your feet to catch any hard skin removed during
treatment.
Remove the protective cap from the roller head.
To switch the Perfect Pedi on, slide the switch up and the roller will start to
rotate.
Glide the roller gently over the hard skin you wish to remove. Do not press
too hard.
After 2-3 seconds, stop and check the skin. Repeat until you have the
desired effect.
DO NOT use in the same area for more than 2-3 seconds at a time.
If the skin becomes sore or inflamed, stop the treatment immediately.
To switch the Perfect Pedi off, slide the switch downwards.
After use, wipe or rinse your feet with warm water.
Apply foot cream for smooth results.
, REPLACING THE ROLLERS
The rollers should last for several treatments.
You should replace the rollers immediately if you see signs of damage, or it
begins to take longer to achieve your normal results.
Replacement rollers are available: SP-CR1
C CLEANING AND MAINTENANCE
To ensure long lasting performance of your Perfect Pedi, clean after each
use.
The easiest and most hygienic way to clean the roller head is by using the
cleaning brush supplied.
This product is not washable.
Ensure the Perfect Pedi is turned off when cleaning.
From time to time wipe the handle with a damp cloth.
When not in use, store with the protective cap attached.
REMOVING BATTERIES
To open the battery compartment, slide the battery compartment lid
downwards.
Lift the batteries from the compartment.
5

Publicité

Table des Matières
loading

Table des Matières