Kenwood LZ-T700 Mode D'emploi page 11

IMPORTANT REAR SUPPORT ARM
5
Push in the two buttons at the sides of
the rear support arm and rotate it up
until it makes contact with the seat back.
Release the buttons and the support arm
will stay in that position.
Place the LZ-T700 in the bottom edge of
6
the tray A first, then snap the corners
back Into place.
Carefully align the two T-notch slots on
7
the tray A with the feet on the base B.
With the T-notch feet inserted into the
8
slots press the tray A downward to lock
the assembly in place. NOTE: The tray A
will also quick-release from the base unit
by simply pressing slightly to the right
until Is unsnaps.
B64-5135-00_00_K.indb 11
Adjusting the mount
360º ROTATION
The LZ-T700 can be rotated for
Landscape or Portrait viewing. Carefully
rotate the tray holder into the desired
position.
SLIDE LEFT/ RIGHT
Loosen the adjustment collar and
slide the tray to the left or tight to the
desired position. Tighten the collar when
finished.
A
SWIVEL/ TILT VIEWING ANGLE
Loosen the adjustment collar and
carefully swivel or tilt the tray to the
desired position. The range of motion
is limited. Do not force or apply excess
pressure! Tighten the collar when
finished.
11
English
13/02/22 15:5