Installation; Installing The Base - Kenwood LZ-T700 Mode D'emploi

Installation

Part list:
A Mounting Tray Holder .......................................(×1)
Purchase the "SCOSCHE, Universal
IPDHM2 Headrest Mount for All iPad
Models."
B Headrest-mount base unit .............................(×1)
• The following parts are not used.
Tray holder for iPad .............................................(×1)
Foam spacers for iPad 2 .................................. (×2)
!Warning
A driver must not watch or operate the
■ ■
screen while driving.
In order to prevent accidents caused by
■ ■
abrupt stops, be sure that the passengers in
the rear seat have their seatbelts fastened.
To ensure safety, installe in a place where it
■ ■
does not interfere with visibility or driving
operation.
!Caution
To prevent the LZ-T700 from falling, check
■ ■
that base B is firmly fixed in place.
Remove the LZ-700 from base B when
■ ■
driving on rough terrain or bumpy roads.
Failure to do so can cause the LZ-T700 to fall
or damage the headrest.
Leaving the LZ-T700 in a closed up vehicle,
■ ■
or exposed to direct sunlight for prolonged
periods of time can cause deformation or
malfunction of the LZ-T700. If under such
condition, be sure to remove the LZ-T700
from base B and store it in a safe place.
Application of excessive force may damage
■ ■
the headrest.
10
B64-5135-00_00_K.indb 10
English

Installing the base

Loosen the two knobs to expand the
1
mounting clamp on the base B.
Carefully remove the headrest from the
2
seat back.
Place the base B on the top of the seat
3
back so the slots line up directly over the
holes for the vehicle's headrest posts.
Re-install the headrest and tighten the
4
two clamping knobs on the base B.
B
13/02/22 15:5