Installing Wire Guide And Drive Roll - Miller RAD-400EF Manuel Du Propriétaire

4-7. Installing Wire Guide And Drive Roll

6
5
4
3
2
.
Tools Needed:
1/4 in.
Motor shown without feed roller guard.
1
.
When changing wire size or
type, check drive roll size
(see Table 5-1).
1 Wire Pressure Adjustment
Screw
Loosen screw to decrease tension
on spring.
2 Drive Roll Nut
3 Drive Roll
Remove drive roll.
4 Drive Roll Carrier
Turn nut one click to line up lobes
with lobes on drive roll carrier.
5 Wire Guide Securing Screw
(Hidden)
Loosen wire guide screw.
6 Inlet Wire Guide (Supplied
With Wire Straightener Kit)
Remove inlet wire guide.
Install drive rolls, and turn drive roll
nut one click.
254 579-A
OM-256 907 Page 15