GE Profile JGP329 Instructions D'installation page 15

3 CHANGE COOKTOP BURNER
ORIFICES (CONT.)
D Locate the Propane (LP) orifices attached to
the regulator along with separate Propane
(LP) conversion instructions. They will have a
digit for size, and a letter for type of gas, on
the top or side. (Important: Save the orifices
removed from the appliance for future use.)
Each orifice will show a series of engraved
marks, (I, II, III, X or none), located on the top.
These marks denote the precise location of each
orifice to the cooktop burner.
I II
15,000 BTU/HR Burner
(on some models)
The 15,000 BTU/HR burner has two orifices with
markings located in the sides only. (See rating
plate on bottom of appliance).
NOTE: The main orifice is located low in the center
of the burner while the simmer orifice is located
higher behind the center of the burner.
Simmer
orifice
Installation Instructions
III
X
Main orifice
15
JGP329
86 L
86 L
JGP333 & PGP943
92 L
86 L
JGP940
84 L
91 L
Install the Propane (LP) orifices in their precise
E
locations as noted in the illustrations above.
Return the natural gas orifices to the bracket
F
and reattach the bracket and the instruction
sheet to the pressure regulator using the
screw removed previously.
G Replace the burner bases, heads, caps and
top grates. (NOTE: When re-attaching the
burner bases to glass top units, tighten screws
to a maximum of 10 in.-lbs torque.)
63 L
92 L
63 L
See
Below
Main: 99 HXL
Simmer: 34 SL
74 L
104L
X